KINGSTON 2GB 1333MHz DDR3 Non-ECC CL9 DIMM

KVR1333D3N9/2G
2GB 256M x 64-Bit PC3-10600
CL9 240-Pin DIMM
ValueRAM 256M x 64-bit 2GB (2048MB) DDR3-1333 CL9 SDRAM (Synchronous DRAM) memory module, based on sixteen 128M x 8-bit DDR3-1333 FBGA components. The SPD is programmed to JEDEC
standard latency 1333Mhz timing of 9-9-9 at 1.5V. This 240-pin DIMM uses gold contact fingers and requires +1.5V
Základní vlastnosti:
JEDEC standard 1.5V ± 0.075V napětí
VDDQ = 1.5V ± 0.075V
667MHz fCK for 1333Mb/sec/pin
Programovatelná CAS Latency: 5,6,7,8,9,10
Programovatelná Additive Latency: 0, CL - 2, or CL - 1 clock
Programovatelná CAS Write Latency(CWL) = 9(DDR3-1333)
8-bit pre-fetch
Burst Length: 8 (Interleave without any limit, sequential with starting address “000” only), 4 with tCCD = 4
which does not allow seamless read or write [either on the fly using A12 or MRS]
Bi-directional Differential Data Strobe
Internal(self) calibration : Internal self calibration through ZQ pin (RZQ : 240 ohm ± 1%)
On Die Termination using ODT pin
Průměrný refresh 7.8us při teplotě TCASE 85°C, 3.9us při 85°C < TCASE . 95°C
Asynchronní resetování
1066Mbps CL7 není zpětně kompatibilní s 800Mbps CL5
PCB : výška 1.180” (30.00mm), double sided
Výkon:
CL(IDD) 9 cyklů
Row Cycle Time (tRCmin) 49.5ns (min.)
Refresh to Active/Refresh Command Time (tRFCmin) 90ns
Row Active Time (tRASmin) 36ns (min.)
Power TBD W (operating)
UL Rating 94 V - 0
Pracovní teploty od 0o C do 85o C